AmeriGlide GARDTEC 350+ Manual de usuario

Gardtec 350+2897PDFGARDINER TECHNOLOGYGardtec 350+Quick StartUser Guide

The display will show.The display will show.The display will show.When you have finished testing the system press.This is Test Mode.You may now ‘walk

Viewing The LogWith the system in Day Mode (Unset).The display will show.The display will show.The display will show.

The display will now show the last system event and will vary dependant on whatthat event was.Whilst using the Log Mode the No key is used to move to

Turning Chime On/OffChime zones will have been previously programmed by your installation engineer. AMaster level user may turn the Chime function On

The display will show.The display will show.To Escape back to Day Mode.Programming User CodesUp to nine user codes may be programmed into the 350+ con

The sequence for programming User Codes is.Enter User Code Programming ModeEnter the User Number (1 to 9) you wish to programEnter the Code you requir

The display will show.The display will show.The display will show.

The display will show.The display will show.The display will show.Enter User Number(1 to 9)Note:Tamper LED has rapid flashEnter New CodeNote:Tamper LE

The display will show.The display will show.To Escape back to Day ModeNote: To delete a User Code enter 0000 as the New Code. User Number 1 isthe main

IntroductionThis Quick Start Guide is intended to help end users who are new to securitysystems in the day to day use of the system.We recommend that

Tampers & PAsYour security system protects itself against tampering. In the event of any controlequipment, detectors or sounders being opened or c

Power LEDThe Power LED gives an indication of that the mains supply to the unit is good. Itshould be illuminated at all times except when User Program

To Part Set the SystemThen retire to an unprotected areaNote: Your engineer may have programmed the Part Set exit sounders as silent.If so a single be

Resetting After An AlarmAfter an alarm all the LEDs will be flashing. Pressing No will display the cause of thealarm for 3 seconds. For example.System

User Programming ModeTo enhance the flexibility of the Gardtec 350 control panel there are five userprogrammable options available.When programming th

TESTThis option allows a Master User to test the system zones and sounders.LOGThis option allows a Master User to view the system Event Log.CHIMEOne o

The display will show.If you wish to Remove more zones return to *ORTo set the system with the Zone(s) you selected RemovedExit WaitAfter exiting and